Siko AP10S - 04 h: Keys Enable Time: Configuration Start Delay

Communication via SIKONETZ 5
AP10S Date: 04.09.2017 Art. No. 87826 Mod. status 269/17 Page 27 of 48
6.9.4 03h: Response parameter to a set point write access
Parameter address
03h
Description
This parameter defines the response to the command
"Write set point"
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
0
Data content
0 = set point
1 = actual value
2 = differential value
6.9.5 04h: Keys enable time: Configuration start delay
Configuration start delay (key enable time) is set via parameter 04h.
Parameter address
04h
Description
Duration of key actuation to start configuration.
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
5
Data content
1 … 60 s
6.9.6 05h: Key function enable1: Calibration enable
The parameter 05h indicates whether calibration of the position value is enabled via key
actuation.
Parameter address
05h
Description
Key enable
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
1
Data content
0: Calibration disabled
1: Calibration enabled