Siko AP10S - 06 H: LED Flashing; 07 H: LED3 (Green Right); 08 H: LED2 (Red Left)

Communication via SIKONETZ 5
AP10S Date: 04.09.2017 Art. No. 87826 Mod. status 269/17 Page 28 of 48
6.9.7 06h: LED flashing
Flashing of the LEDs can be set via parameter 06h (see chapter 3.3: LED display). This setting
applies to all LEDs.
Parameter address
06h
Description
Flashing of all LEDs
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
0
Data content
0 = no flashing
1 = any glowing LED is flashing
6.9.8 07h: LED3 (green right)
LED3 (green, right) can be set via parameter 07h (see chapter 3.3: LED display). The control
word can be freely accessed only if the LED is switched off here.
Parameter address
07h
Description
LED green right (LED3)
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
1
Data content
0 = Off
1 = position-dependent
6.9.9 08h: LED2 (red left)
LED2 (red, left) can be set via parameter 08h (see chapter 3.3: LED display). The control word
can be freely accessed only if the LED is switched off here.
Parameter address
08h
Description
LED red left (LED2)
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
1
Data content
0 = Off
1 = position-dependent