Overview of parameters
AP10S
Date: 04.09.2017 Art. No. 87826 Mod. status 269/17 Page 16 of 48
Position value = 0 + calibration value + offset value
Calibration value (see object 1Fh: Calibration value)
Offset value (see object 1Eh: Offset value)
4.6.3 Restore factory settings
There are various options for restoring the factory settings of the device:
Factory settings are restored
all except bus parameters
SIKONETZ5
(see parameter A0h:
System commands)
all except bus parameters
Table 8: Access to factory settings
4.6.4 Diagnosis
To receive a list of device errors that occurred switch the device to the diagnosis mode. Enter
CODE "200000" in parameterization (see chapter 4.3.1: Manual parameterization) and confirm
by pressing the key. Any errors occurring are output indicating the error number and total
of occurrences in the upper row. The type of error is shown in the lower row. Error number 1
contains the latest error. The oldest error is output with the highest error number.
5 Overview of parameters
Baud rate of the RS485 interface
Indication of bus timeout in x100 ms
03h: Response parameter to a set
point write access
Defines the response to the command
"Write set point"
04h: Keys enable time:
Configuration start delay
Period of key actuation in order to start
configuration.
05h: Key function enable1:
Calibration enable
To Next Page
Loading...
