Siko AP10S - 39 H: LED4 (Red Right); 3 Ah: LCD Backlight Flashing; 3 Bh: LCD Backlight White

Communication via SIKONETZ 5
AP10S Date: 04.09.2017 Art. No. 87826 Mod. status 269/17 Page 37 of 48
6.9.31 39h: LED4 (red right)
The LED4 (red, right) can be set via parameter 39h (see chapter 3.3: LED display). Free access
via the control word is only enabled if the LED is switched off here.
Parameter address
39h
Description
LED red right (LED4)
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
1
Data content
0 = Off
1 = position-dependent
6.9.32 3Ah: LCD backlight flashing
Flashing of the LCD backlight can be set via parameter 3Ah. This setting applies to either
color.
Parameter address
3Ah
Description
Flashing of the LCD backlight
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
0
Data content
0 = no flashing
1 = the current backlight is flashing.
6.9.33 3Bh: LCD backlight white
The white LCD backlight can be set via parameter 3Bh.
Parameter address
3Bh
Description
LCD backlight white
Access
rw
EEPROM
yes
Programming mode
yes
Data type
UNSIGNED 8
Default
1
Data content
0 = Off
1 = On