Siko AP10S - Error Number Encoding; Service Protocol Commands List

Communication via Service Standard Protocol
AP10S Date: 04.09.2017 Art. No. 87826 Mod. status 269/17 Page 48 of 48
7.2 Error number encoding
The following error messages are returned in case of wrong input.
Error number
Description
?1
input of illegal parameter number
?2
illegal value range
Table 18: Error number encoding
7.3 Service protocol commands list
Command
Length
Reply
Description
Ay
2/17
"AP10 SN5 zW xxxx>"
Device type / software version
y=0: hardware version; z = H
y=1: software version; z = S
L
1/2
">"
Calibration (see chapter 4.6.2: Calibration)
Sxxxxx
6/2
">"
System commands
x=00100: start alignment (see chapter 4.6.1:
Alignment travel)
x=11100: all parameters into basic state
After restart, the factory settings will be
active, this applies to bus protocol and baud
rate as well.
x=11101: reset all to factory settings, except
bus parameters
x=11102: only bus parameters into basic state
x=11105: activate bootloader
Z
1/11
"±xxxxxxxx>"
Output actual position
Table 19: Service protocol commands list