Using T-GEN 50 with 4100ES-S1, Continued
An optional three-position control ME0460 (see part numbers in Chapter 1) allows the T-
GEN 50 to be switched from the front panel between automatic operation, being Isolated,
or producing Evacuation tone, regardless of the state of other control inputs.
With the control in the ISOLATE position, the T-GEN 50 will not respond to the ALM-
input, nor activate its FAULT output if a fault is present. Note that this condition is not
indicated on the 4100ES-S1 operator interface, so care must be taken when using this
facility.
With the control in the EVAC position, the T-GEN 50 will immediately produce
Evacuation tone.
Figure 5-7 shows how to connect an Evacuation Control to a T-GEN 50.
The control can be fitted to an FP0935 or FP0937 4U Brigade Interface door as used in
4100ES-S1, or fitted to a 4100-1279 blank display module (requires a 9.5mm hole to be
drilled in the display module – the ME0460 includes an installation guide with drilling
details). See Figure 5-8 for example.
Figure 5-7. Wiring an Evacuation Controller to a T-GEN 50
The T-GEN 50 can be fitted with a compatible PA microphone, to allow voice
announcements via the warning system. ME0490 is a suitable part for the 4100ES-S1
(see part numbers in Chapter 1)
A suitable recess or cavity is required for storing the microphone while not in use. The
FP0935 and FP0937 4U Brigade doors have a suitable recess. See Figure 5-7 to see how
the microphone fits and how its lead is routed inside the cabinet.
Continued on next page
To Next Page
Loading...
Need help?
General
