If the unit is totally locked i.e. no immediate response
from the keypad, the unit can be reset by disconnecting
the power supply and then starting up again by simulta-
neously pressing the three keys: 4 + 7 + PWR while the
power cable is being re-connected. Hold the keys de-
pressed for two seconds and then let go.
See below !FTERAMASTERRESET
If the unit is still ’alive’ but has ceased to respond to
normal operation, you can make a limited master reset.
A full reset will erase all data, waypoints, and settings,
and restore the basic settings from the factory.
#ALLMASTERRESETDISPLAY
To activate a MASTERRE
SET, follow the instruc-
tions in the display, or
exit the function without
making any changes by
pressing ;-%.5=.
!FTERAMASTERRESETthe CE32 MKII will start up with
the language display where you have to choose display
and menu language, see sec. 2.2, and then perform a
fully automatic start-up.
-ASTERRESET
KEYSTOPRESS
6,0MENU
-!34%22%3%4
2ETURNTOFACTORYPRESETS
&5,,2%3%4
!LLDATAINCL70SROUTESETCWILL
BEERASED↑↓#,2
,)-)4%$2%3%4
5SERDATA70SROUTESETCWILLBE
PRESERVED↑↓%.4
%XIT-%.5
#HAPTER #%-+)))NTERFACINGANDMASTERRESET
90