This display is only available if the CE32 MKII has a
built-in DGPS receiver. If receiving differential correc-
tions from external receiver, refer to ’Status indicator’
in position display. To receive valid differential data
will require that the navigator is locked in on a beacon
station. F List of Beacon stations, see addendum, part
no. 183.0122.501.
,OAD $'03INFORMATION (with built-in module)
The frequency of the bea-
con station can be set ma-
nually if known, but when
left on AUTO the naviga-
tor will always search for
the nearest one with a
good signal strength.
A good signal strength is
20 and up.
Signal to noise ratio
should be 8dB and up.
How to change the current settings in the DGPS infor-
mation display:
/PENFORCHANGE
'OTOTHEFUNCTIONYOUWISHTOALTER
4OGGLETHEFUNCTIONINSERTFIGURES
#ONFIRMENTRY
DGPS information:
Beacon: B***m D**.*nm
Status: LOCKED
Beacon is monitored: YES
Frequency: 314.0kHz AUTO
Bit rate: 100bps AUTO
Signal strength: 22
Signal to noise ratio (SNR): 10dB
$'03INFORMATION
KEYSTOPRESS
2,9MENU
ENT
0-9
ENT
+/-
#HAPTER #%-+))#HARTANDPOSITIONMENUS
32