EasyManua.ls Logo

Simrad GN70 - User Manual

Simrad GN70
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ENGLISH
GN70/MX610/MX612
Operator and Installation Manual
navico.com/commercial

Table of Contents

Other manuals for Simrad GN70

Questions and Answers

  • E
    Elizabeth HayesSep 12, 2025
    How to adjust display brightness on Simrad GN70?
    • B
      Barbara BrownSep 12, 2025
      If the display on your Simrad Marine Equipment is dim, try pressing the power button briefly to increase the backlight brightness.
  • C
    Crystal HollowaySep 14, 2025
    What causes CAN bus failure in Simrad GN70 Marine Equipment?
    • E
      erogersSep 14, 2025
      A CAN bus failure in Simrad Marine Equipment may be due to a poor CAN bus backbone, a defective cable or connector, or a defective CAN bus receiver in the autopilot control unit. To resolve this: 1. Check the backbone terminations. 2. Inspect cables and connectors. 3. Replace the N2K power supply or the MX61xJB junction box unit.
  • R
    Ricardo WoodSep 16, 2025
    How to troubleshoot low CAN bus voltage on Simrad Marine Equipment?
    • R
      Ricky WheelerSep 16, 2025
      Low CAN bus voltage on your Simrad Marine Equipment may be improved by checking the cable length, bus load, and bus supply feeding point. If possible, determine if the issue resolves by disconnecting some units.
  • D
    Dr. Lindsay BlairNov 23, 2025
    What to do if Simrad Marine Equipment unit fails to detect the antenna?
    • D
      Denise AndersonNov 23, 2025
      If your Simrad Marine Equipment unit fails to detect the antenna, follow these steps: * For N2K antenna models (GS70 or HS80), ensure the antenna is properly connected, the cable connector is in good condition, and there is no damage to the cable. * Verify that the dedicated 12 VDC supply to the N2K network is available and cycle the power to the N2K bus. * Confirm that the antenna is selected as the data source under the main Menu/Network/Sources page. * Ensure N2K terminators are installed at both ends of the NMEA 2000 bus. * For MX521A or MX575C/D antennas connected to Port 3 of the MX61xJB: 1. Ensure Port 3 of the MX61xJB is configured to match the baud rate setting of the MX antenna (4800 or 19,200). 2. Verify that MXJB Port 3 is selected as the source of position...

Simrad GN70 Specifications

General IconGeneral
Display TypeTFT LCD
Display Resolution800 x 480 pixels
GPSYes
ChartplotterYes
SonarNo
Waterproof RatingIPX7
AISYes
Operating Voltage12/24 V DC
CompassYes
Power Supply12/24 V DC
Operating Temperature-15°C to +55°C
NetworkingNMEA 2000
Display Size7 inches
GPS ReceiverHigh-sensitivity
Storage Temperature-20°C to +70°C

Related product manuals