Simrad NSO evo3S MPU - Card Reader; USB Port

Menu button
Displays the menu of the active panel. Use menu options to customize the image. The panel
menu options are further explained later in this manual in each application chapter.
Instrument bar
The instrument bar displays information from sensors connected to the system.
By default, the instrument bar is shown on the panel. You can turn the instrument bar off.
You can select the predefined bar to be shown and you can change the information
displayed in the predefined bar. Refer to "Customizing the instrument bar" on page 18.
Control bar
The control bar contains buttons for launching controllers or features enabled in your
system. The different controllers are described in applicable chapters later in the manual.
Card reader
A memory card can be used for:
• Chart data
• Software updates
• Transfer of user data
• System backup
Ú
Note: Do not download, transfer or copy files to a chart card. Doing so can damage chart
information on the chart card.
USB port
The USB port can be used to:
• connect a keyboard
• connect a mouse
• connect a storage device
• connect a card reader
Ú
Note: If you want to read chart cards using a USB card reader connected to the USB port,
an MI10 USB card reader is required.
The USB devices should be standard PC compatible hardware.
Ú
Note: USB cable length should not exceed 5 m when using regular cables. Lengths over
5 m may be possible with the use of an active USB cable.
14
Introduction | NSO evo3S MPU Operator Manual