2. Open the System Controls dialog
3. Select the adjust splits option. The adjustment icon appears on the multiple panel page.
4. Select the adjustment icon and move the split to the desired position
5. Use menu options to save or discard your changes.
Enabling or disabling features
A compatible device connected to the NMEA 2000 network should automatically be
identified by the system. If not, enable the feature from the advanced settings dialog.
Features can also be disabled using this dialog.
Password Protection
You can set a PIN code to prevent unauthorized access to your system's settings. Refer to "PIN
code" on page 135.
Feature unlock
Some additional features can be sold separately. These features can be unlocked by entering
an unlock code.
Select the feature you want to unlock. Follow the instructions to purchase and enter the
feature unlock code.
After a feature unlock code is entered in the unit, the feature is available for use.
Ú
Note: The feature unlock option is only available if your unit supports a locked feature.
Bridge Control
About Bridge Control
The Bridge Control feature allows you to control which pages are shown on several displays
at the same time. The feature is used on vessels with multiple displays mounted in the same
place to quickly configure what information is displayed.
There can be a maximum of four different bridges on your system, and you can have up to
four displays grouped into one bridge. Each display can be configured to only one bridge.
When the displays are included in a bridge, you can configure twelve page configurations
(presets) for each bridge.
20
Customizing your system | NSO evo3S MPU Operator Manual
To Next Page
Loading...
Need help?
General
