Simrad NSO-II User Manual

96 |
GoFreeTM wireless | NSO-II Operator Manual
Setting up multiple WIFI-1 units
On large or metal hulled vessels it may be necessary to connect multiple WIFI-1 access
points to extend the range.
Up to 2 WIFI-1 units can be connected to one NSO-II, but only the WIFI-1 unit dened as
primary access point can be used for connecting the wireless device to the NSO-II.
1. Open the access points’ dialog as shown above
2. Activate the line for the connected WIFI-1 unit, and re-dene this to be a secondary ac-
cess point
3. Connect and dene the additional WIFI-1 unit as described in “Setting up the WIFI-1” on
page 95.
- The latest connected WIFI-1 unit will now be the primary access point, and only this
can be used for connecting the wireless device to the NSO-II.
Selecting communication channel
The WIFI-1 unit will automatically select the channel used for communication with the
wireless devices.
You might need to change the channel if other transmitting devices cause conicts
(multiple networks, wireless phones etc), or if you are using the equipment in areas with
restricted channel selection.
The channels can be manually changed from the drop down list.
¼ Note: Only technically skilled persons should set up multiple WIFI-1 units or change the
communication channel!
Connecting the wireless device to the WIFI-1
Set up the wireless device’s network to be the WIFI-1 dened as primary access point.
- The Network name is found in the NSO-II menu. Refer to “Setting up the WIFI-1” on
page 95.

Simrad NSO-II Specifications

General

Brand	Simrad
Model	NSO-II
Category	Marine Equipment
Language	English