To Next Page
A
Alexandria WhiteJul 30, 2025
What to do if there is no lubricant at lubrication points in SKF Industrial Equipment?
- DdbrownJul 31, 2025
If there's no lubricant at the lubrication points, it could be due to a defective main or secondary metering device. This can be checked by seeing if grease can be pressed through the distributor after removing all union nuts or fittings at the outlets. If so, replace the progressive metering device, loosen all fittings, mark lines, and secure against outside influences. Install a new progressive metering device and lubrication lines in the correct order as marked previously. Remember to only use original SKF spare parts and perform a start-up and functional inspection. Another potential cause is a defective or blocked secondary feed line. In this case, detach the feed line, identify the cause of the blockage, and replace the secondary feed line if necessary.
General