Section 02 LUBRICATION AND MAINTENANCE
Subsection 01 (LUBRICATION AND MAINTENANCE CHART)
MMR2000_115_02_01A.FM 02-01-5
NO. 7 – DRIVE CHAIN CONDITION
Visually inspect the chain for cracked, damaged or
missing link rollers.
Check for defective bearings, sprockets and worn
chain tensioner components.
Lubricate drive chain as per lubrication chart.
Use BOMBARDIER LUBE (P/N 293 600 000).
CAUTION: Always lubricate drive chain slight-
ly. Oil must not contact brake pad.
NO. 8 – RAGS IN AIR INTAKE AND
EXHAUST SYSTEM
At storage preparation, block air intake hole and
exhaust system hole using clean rags.
Remove those rags at pre-season preparation.
NO. 9 – ENGINE COMPARTMENT
Keep clean of grass, twigs, cloth, etc. These are
combustible under certain conditions.
NO. 10 – VEHICLE CLEANING AND
PROTECTION
Remove any dirt or rust.
To clean the entire vehicle, use only flannel clothes
or Kimtowels
®
wipers no. 58-380 from Kimberly-
Clark.
CAUTION: It is necessary to use flannel cloths
or Kimtowels wipers on windshield and hood
to avoid damaging further surfaces to clean.
To clean the entire vehicle, including metallic parts
with a thick coat of grease, use Endust
®
imported
by Bristol Myers, available at hardware stores or
supermarkets.
For bottom pan cleaning, use Bombardier Cleaner
(P/N 293 110 001 (spray can 400 g) and P/N 293
110 002 (4 L)).
CAUTION: Do not use Bombardier Cleaner on
decals or vinyl.
To clean the entire vehicle, including metallic parts
with a thin coat of grease, use Simple Green
®
from Sunshine Makers Inc., available at hardware
stores or at automotive parts retailer.
For vinyl and plastic parts, use Vinyl & Plastic
Cleaner (P/N 413 711 200 (6 x 1 L)).
To remove scratches on windshield or hood: Start
with “Slip Streamer Motorcycle Windshield
Heavy Duty Scratch, Remover”. Finish with “Slip
Streamer Motorcycle Cleaner and Polish”.
NOTE: The latest product may be use alone if only
light scratches are noticeable.
CAUTION: Never clean plastic parts or hood
with strong detergent, degreasing agent, paint
thinner, acetone, products containing chlorine,
etc.
Inspect the hood and repair any damage. Touch up
all metal spots where paint has been scratched
off. Spray all metal parts with BOMBARDIER
LUBE (P/N 293 600 016). Wax the hood and the
painted portion of the frame for better protection.
NOTE: Apply wax on glossy finish only. Protect
the vehicle with a cover to prevent dust accumu-
lation during storage.
CAUTION: The snowmobile has to be stored in
a cool and dry place and covered with an
opaque tarpaulin. This will prevent sun rays
and grime from affecting plastic components
and vehicle finish.
Lift rear of vehicle until track is clear of the ground.
Install on a snowmobile mechanical stand.
NOTE: Do not release track tension.
To Next Page
Loading...
Need help?
General
