SMA CLUSTER CONTROLLER User Manual

18.4 Resetting the ClusterController
You can reset the ClusterController via the keypad.
Procedure:
1. Call up the display view Settings. To do this, simultaneously press and hold the [OK] and [
ESC] buttons on the keypad for two seconds.
☑ The display view Settings opens.
2. Select the settings that are to be reset:
Settings to be reset Explanation
Reset password The user password and the installer password are re-
set.
Reset network settings The network settings of the ClusterController are reset.
Reset to default settings The ClusterController is reset to the default settings.
Stored system data is deleted.
3. To exit the display view, press [ESC].
4. To confirm the settings that are to be reset, perform the following steps:
• Press [OK].
☑ The display view Confirm the resetting appears.
• Select OK and confirm with [OK].
☑ The selected settings are reset.
☑ If the network settings were reset or the ClusterController was reset to default settings, the
ClusterController restarts.
5. If you are using SunnyPortal and the ClusterController has been reset to default settings,
adjust the PV system identifier for SunnyPortal in the ClusterController (see Section11.6,
page59).
18 Troubleshooting
SMA Solar Technology AG
User Manual 109ClusterController-BA-en-15

SMA CLUSTER CONTROLLER Specifications

General

Data Logging	Yes
Display	LCD
Power Supply	24 V DC
Remote Monitoring	Yes
Protection Class	IP20
Communication Interfaces	Ethernet
Product Type	Controller
Manufacturer	SMA