SMA CLUSTER CONTROLLER

• Select [Edit].
• In the field Activated, select the entry Yes.
• If the e-mail is to be displayed in a language other than the currently configured
language, select the desired e-mail language in the drop-down list Language.
• In the field E-mail address(es), enter the recipient's e-mail address. If more than one
e‑mail address is to be entered, separate each of the e-mail addresses with a comma or a
semicolon.
5. If required, set a filter for the alarm:
• Select the group Filter settings.
• If there is to be no alarm for reactive power setpoint events, select the entry No in the
drop-down list Alarm at reactive power setpoint.
• If there is to be no alarm for active power limitation events, select the entry No in the
drop-down list Alarm at active power limitation.
6. Select [Save].
7. Test the alarm via e‑mail:
• Select the group E-mail.
• In the field Send test e-mail, select [Execute].
☑ The ClusterController sends a test e-mail to the given e‑mail address. OK is displayed in the
field Result of the last e-mail dispatch.
✖ The test e-mail could not be sent?
Possible error cause: You have entered the e-mail address incorrectly, there is no Internet
connection or the ClusterController network settings are faulty.
• Correct the e-mail address entered.
• Establish an Internet connection.
• Ensure that the SMTP settings of the ClusterController are correct.
• If there is a proxy server in your LAN, ensure that the proxy settings of the
ClusterController are correct.
✖ You did not receive the test e-mail?
• Check the spam folder of your e-mail inbox.
• Check the local network settings and adjust if required.
9 System Monitoring
SMA Solar Technology AG
User ManualClusterController-BA-en-1552