SMART M600i6 User Manual

CHAPTER 3
USING YOUR INTERACTIVE WHITEBOARD SYSTEM
16 smarttech.com/kb/170549
Setting Use Notes
Status Displays the current network
status (Connected,
Disconnected or Off).
The default is off.
DHCP Displays the status of the
network’s Dynamic Host
Configuration Protocol (DHCP)
as On or Off.
The default is on.
On enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off enables an administrator to assign an IP
address manually.
Password
Reminder
E-mails the network password
to the predefined e-mail
recipient.
See Web page management on page45 to
set up a destination e-mail address.
IP Address Displays the projector’s current
IP address in values between
0.0.0.0 and 255.255.255.255.
To change the projector’s IP address, use the
RS-232 connector or use a DHCP server to
assign a dynamic IP address, and then set a
static IP address using the network remote
management feature (see Remotely
managing your system through a network
interface on page45).
Subnet Mask Displays the projector’s subnet
mask number in values
between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector’s default
network gateway in values
between 0.0.0.0 and
255.255.255.255.
DNS Displays the projector’s primary
domain name server (DNS) IP
address in values between
0.0.0.0 and 255.255.255.255.
MAC Address Displays the projector’s MAC
address in xx-xx-xx-xx-xx-xx
format.
Group Name Displays the projector’s
workgroup name as set by an
administrator (maximum 12
characters).
You can set the projector’s workgroup name
using the remote management features (see
Remotely managing your system through a
network interface on page45 and Remotely
managing your system through an RS-232
serial interface on page53).

SMART M600i6 Specifications

General

Brand	SMART
Model	M600i6
Category	Interactive whiteboard
Language	English