SMC Networks HRS Series - Page 45

DOC1001322
Chapter 3 Transport and Setting Up
HRS Series 3.3 Installation
3-29
 How to connect piping
Hold the each piping port with a wrench and tighten the piping.
Fig. 3-14 Tightening of piping
 How to connect to the drain port
When piping the drain port, hold the ball valve of the drain port with a wrench not to rotate it.
Fig. 3-15 Connection to the drain port
Without holding the ball valve of the drain port with a wrench, the ball
valve may rotate and it may cause a fluid leakage and/or malfunction of
the product. Be sure to hold the ball valve of the drain port.
Tank drain port
Hold the ball valve.
Sealant
Connection port
Connect the strainer
so that the screen
faces downward.
Arrow direction of Y strainer
Note: When using the Y strainer
of the accessory, fasten it on the
return port.
Clean the filer of the strainer
after the trial operation before
starting the proper operation
Sealant
Y strainer
25A
Barrel
nipple 25A