HRX-OM-M090
Chapter 3 Transport and Setting Up
3.2 Installation HRS Series
3-4
3.2.1 Environment
The product must not be operated, installed, stored or transported in the
following conditions. Potential malfunction or damage to the product may
occur if these instructions are disregarded.
The product does not conform to any Clean room specifications. The pump
and ventilating fan inside the product generate particles.
The installer/end user is responsible for carrying out an acoustic noise risk
assessment on the equipment after installation and taking appropriate
measures as required.
z
Location that is outside.
z
Location that is exposed to water, water vapour, steam, salt water or oil.
z
Location that is exposed to dust or powder material.
z
Location that is exposed to corrosive gas, organic solvent, chemical
solution, or flammable gas (the product is not flame-proof)
z
Location where the ambient temperature is out of the following range:
In transportation and In storage 0 to 50°C
(with no water or circulating fluid in piping)
In operation 5 to 40°C (Option G [High temperature
type]:5 to 45°C)
z
Location where the ambient humidity is out of the following range or where
condensation occurs:
In transportation and storage 15 to 85%
In operation 30 to 70%
z
Location that is exposed to direct sunlight or heat radiation.
z
Location that is near heat sources and poor in ventilation.
z
Location that is subjected to abrupt changes in temperature.
z
Location that is subjected to strong electromagnetic noise (intense electric
field, intense magnetic field, or surges).
z
Location that is subjected to static electricity, or conditions where static
electricity can discharge to the product.
z
Location that is subjected to strong high frequencies raditation
(microwaves).
z
Location that is subjected to potential lightning srtike.
z
Location at altitudes of 1000m or higher (except for product storage and
transport).
z
Location where the product is affected by strong vibrations or impacts.
z
Condition that applies external force or weight causing the product to be
damaged.
z
Location without adequate space for maintenance as required.
To Next Page
Loading...
