HRX-OM-M090
Chapter 4 Starting the Product
HRS Series 4.4 Starting and Stopping
4-7
Except in case of emergency, do not turn off the power supply switch
until the product has stopped completely. Doing so could cause
failure.
4.4.2 Stopping the product
1. Press the [RUN/STOP] button on the operation panel.
The [RUN] lamp on the operation panel flashes green at 1 second intervals, and
continues operation to prepare to stop. After approx. 15 seconds, the [RUN] lamp goes
off and the product stops.
Fig. 4-9 Stopping the product
2. Turn off the power supply switch.
All LEDs go off.
Flash
OFF
Press
Be sure to shut off the breaker of the facility power supply (the user’s
machine power supply) before wiring.
Also, drain the circulating fluid, etc. from the product in accordance
with and put into storage properly
To Next Page
Loading...
