SMC Networks HRS012-A*-10-* - Function to Recover from Power Failure

HRX-OM-M090
Chapter 5 Display and setting of various functions
5.9 Function to recover from power failure HRS Series
5-26
5.9 Function to recover from power failure
5.9.1 Function to recover from power failure
When the power supply is cut due to power failure etc., this function restarts
the operation when the power supply recovers, retaining the conditions
before the power cut.
【When communication is used】
If the communication mode is DIO REMOTE, SERIAL mode (MODBUS), this
function does not start. The signal of start/stop of DIO REMOTE SERIAL
mode (MODBUS) has priority.
The [
] lamp lights when the power failure recovery is set. The default
setting of this function is “OFF”.