18
|
Hardware
3. Turn off the machine and unplug all the cables (except for the ones for the Power Module and Touchscreen)
from the Controller.
4. Connect one of the three toolheads to the machine and turn on the machine. See if the machine can detect
the toolhead and work properly.
- If not, turn off the machine and plug in another toolhead. Repeat step 3 till you have tested all of the
toolheads.
- If yes, the problem might be with the Linear Modules.
Please contact us at support@snapmaker.com with your test results for further troubleshooting.
To Next Page
Loading...
