Snapmaker 2.0 - Laser Module Emits Weak Laser

|
31
Laser Module Emits Weak Laser
The Laser Module emits weak light and doesn't engrave at its full power, and therefore the module can't finish
Auto Focus.
Possible causes
• The Enclosure's door is open during Auto Focus.
• The Laser Height is too high.
• The Laser Module is malfunctioning.
Actions
1. If some of the lines that are engraved during Auto Focus are discontinuous as shown in the picture below,
please contact us at support@snapmaker.com for further assistance. If not, go to step 2.
2. Close the enclosure doors before you start to use the Laser Module. For safety concerns, the power of the
laser will be limited at 0.5% if the door is open.
Or, if you need the door open when using the Laser Module, turn off the Door Detection feature. On the
Touchscreen, tap Enclosure > Settings > Door Detection.
× √
Wear the Laser Safety Goggles when
the door is open.