56
Charging
It takes up to 11 hours for the conference phone battery to be fully charged (the
battery icon has 3 bars ). When the conference phone is fully charged, you can
expect the following operating times:
Operation Operating time
While the conference phone is in use
(talking)
Up to 5 hours
he conference phone is not charging and
not in use (standby)
Up to 7 days
The battery needs charging when:
• A new battery is installed into the conference phone.
• The battery icon has no bars and is flashing .
CAUTION:
To reduce the risk of fire or injury, read and follow these instructions:
• Use only the batteries provided or equivalent. To order a replacement, visit our
website at snomamericas.com.
• Do not dispose of the batteries in a fire. Check with local waste management
codes for special disposal instructions.
• Do not open or mutilate the batteries. Released electrolyte is corrosive and
may cause burns or injury to the eyes or skin. The electrolyte may be toxic if
swallowed.
• Exercise care in handling batteries in order not to create a short circuit with
conductive materials.
• Charge the batteries provided with or identified for use with this product only in
accordance with the instructions and limitations specified in this manual.
• Observe proper polarity orientation between the battery and metallic contacts.
• To prevent fire or shock hazard, do not expose this product to water or any type of
moisture.
Battery disposal
Disposal of electrical and electronic products and of batteries should be done in line
with local regulations. Please contact local authorities for further information.
Conference phone battery
To Next Page
Loading...
