Snom C620 - Technical Specifications; Important Battery Information,,63

63
The declaration of conformity can be downloaded at
www.snom.com/conformity.
SELV (Safety Extra Low Voltage) Compliance: Safety status of input/output
connections comply with SELV requirements.
Unauthorized opening, changing, or modifying the device will cause the
warranty to lapse and may also result in the loss of conformity. In case of
malfunction contact authorized service personnel, your seller, or Snom.
Technical specications
• Safety: IEC 62368-1
• Connectors:
◦ Base station:
- 1 x RJ45 (Ethernet) - LAN
- 1 x coaxial power port
◦ Charging dock: 1 x coaxial power port
• Ethernet: 10/100 MB
• Batteries
◦ Phone: CORUN, model no. Ni-MH 18670-4000 7.2V
◦ Wireless mics: CORUN, model no. Ni-MH 2/3AAA400mAh 2.4V
• Power over Ethernet (base station): IEEE 802.3af, Class 2. If PoE not
available, a power adapter is available separately.
• Power adapter
◦ Base station:
- Manufacturer Mass Power, model no. NBS12E050200UV (not included
in delivery)
◦ Charger:
- EU: Csec - model no. CS36M120300FGF
- UK: Csec - model no. CS36M120300FBF
- AU: Csec - model no. CS36M120300FAF
• DECT: 5 registers (2 wireless mics + 3 others)
• Optimal distance between base unit or wireless mic and participant: 60 cm
• Minimum distance between microphones : 30 cm
Important battery information
Use only the batteries that came with the product or contact Snom if you
need replacement batteries. Caution: do not use any other type of battery
since this may lead to leakage, re, explosion, or other dangerous situations.
Never disassemble, alter, or short-circuit batteries or use them for purposes
other than the intended one. Charge batteries only within the phone and the
detachable wireless microphones.
Charging and discharging, storage
• The full performance of a new batteries is achieved only after two or three
complete charge and dis-charge cycles.