5. Select the CE.Connect!Agent.160s.ARM… CAB file and
press the Enter button on the right side.
6. In the options window, select Run and press the Enter button
on the right side.
7. Follow the instructions on your screen to install
Connect!Agent.
8. After you finish Connect!Agent installation, navigate to
where you saved the CE.SocketScan.160s.ARM… CAB file and
run it.
STEP 2: TURN ON THE CHS
Press and hold the small power button for 3 seconds, until
the LED turns blue and the scanner beeps. The LED should blink
blue once per second to show that the Bluetooth radio is on but
not connected.
Time after turning on scanner Bluetooth mode
0-5 minutes Discoverable and connectable
5-10 minutes Connectable
10-20 minutes Not discoverable or connectable
20 minutes Scanner automatically powers off
CHAPTER 4: SETUP FOR INTERMEC CK30 33
To Next Page
Loading...
