APPENDIX F
R
ESTORING FACTORY DEFAULTS
To restore the CHS to its factory defaults, do the following:
1. Turn on the CHS. Make sure the CHS does not have a Bluetooth
connection.
2. While pressing the trigger button, briefly press and release the
power button.
3. Wait 15 seconds or until you hear a single beep.
4. Release the trigger button. If you performed the actions
correctly, multiple beeps will sound, and the CHS will power
off.
5. The next time you power on the CHS, it will reset the virtual
memory and scan engine to their factory default settings.
APPENDIX F: RESTORING FACTORY DEFAULTS 97
To Next Page
Loading...
