If your CK30 suspends or the CHS moves out of range, the
connection will end. After the mobile device turns on again or
returns in range, SocketScan will try to re-connect for
approximately 3 minutes. If, after 3 minutes, they have not re-
connected, you will need to manually re-connect them.
DISCONNECTING
In the SocketScan menu, press 2 Disconnect Cordless Scanner.
Turning off the CHS
To turn off the CHS, press and hold the power button at least 3
seconds, until the blue LED turns off.
CHAPTER 4: SETUP FOR INTERMEC CK30 37
To Next Page
Loading...
