DDAAWW CCoonnttrrooll
33--2299
FFoooottsswwiittcchh CCoonnttrrooll
Duality SE has two 1/4” jack footswitch connectors on the rear of the console. These are intended for hands-free
access to essential transport functions:
Footswitch Control 1 either plays or stops the DAW. Holding down SHIFT will abort a recording if in record, or
initiate half-speed playback if stopped.
Footswitch Control 2 s used to activate or deactivate record mode. Holding CTRL while pressing the footswitch
will cycle through record modes.
ZZoooomm,, NNaavviiggaattiioonn aanndd SSeelleeccttiioonn MMooddeess ((1166))
The Motion Control area has a section with four cursor buttons and a ZOOM/SEL function that toggles the
selection of three available modes: Navigation Edit, Zoom and Select.
Navigation Mode (Zoom/Sel button not lit)
In this mode the cursor buttons can be used to select a region or regions on the DAW screen.
The left and right buttons will snap to region/clip boundaries. The up/down buttons move the cursor to the track
above or below respectively. Holding down the SHIFT modifier button will allow a selection to be extended in
any direction. Holding the OPTION button allows the current selection point to be centred on the screen.
Holding CTRL + Up/Down/Left/Right cursor button allows you to change and extend the region/clip
selection. Add SHIFT to the above combination to include either the previous or next region.
Zoom Mode (Zoom/Sel button lit)
The cursor buttons now become horizontal and vertical zoom controls for the edit/arrange window on the DAW.
Fixed edit/arrange zoom settings can be saved or recalled from Duality SE’s numeric keypad:
To save a zoom setting — press SHIFT + numeric keypad number
To recall a zoom setting — press OPTION + numeric keypad number
DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall
To Next Page
Loading...
Need help?
General
