AAuuttoommaattiioonn
Automated mode: Red LED. All automated moves are written at the current fader position.
Manual mode: No LEDs. The fader operates as a monitor fader only, ie. no information will be
written to memory.
Pressing the CANCEL button (in the ‘AUTOMATION’ group above the ‘TRANSPORT’ buttons) twice quickly will
return you to the List Mix page. See Dedicated Automation Buttons for more information.
To start a Mix, press the Execute key. The screen flips to show a bargraph display of fader levels for the eight
centre section group master faders and the three A, B, C mix Bus Master faders. Channel fader levels are shown on
the channel bay TFT displays.
The system saves a global ‘static’ reference Mix of each fader level and switch status when the Execute key is
pressed. This is useful because it allows you to locate before the start of the Mix and recover your original levels
(ie. reference Mix).
If you are writing automation in a section that had no previous mix data, when you drop out of Write the faders
will return to their original levels.
55--99DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall
To Next Page
Loading...
Need help?
General
