PPrroo TToooollss SSeettuupp NNootteess
To set up timecode generation, go to Setup / Session and select the MTC option:
Now go to Setup / Peripherals and select the Synchronisation tab. Select the port on the MIDI interface
that is connected to Duality SE’s physical MIDI port 8 or select ipMIDI Port 14 . Also select the timecode rate for
the session and the session start time.
It is essential to make a note of the timecode standard that was used for a particular Duality SE mixing
project. The automation system automatically detects the timecode standard from the incoming MTC
messages. It will quite happily attempt to play out stored mix data to incoming timecode with a different
frame rate, but this will result in small but potentially annoying timing errors in automation playback.
AAuuttoommaattiioonn
55--2233DDuuaalliittyy SSEE OOppeerraattoorr’’ss MMaannuuaall
To Next Page
Loading...
