121
Managing Images Using a DDR/VTR
Chapter 7 Frame Memory
For extraction as a pair file, the main file and sub file must
have the same number of frames.
1
In the Frame Memory >Clip >Record menu (2523),
record the tape image as a clip (1 p. 114).
2
Open the Frame Memory >File >Auto Extraction
menu (2542).
3
Select a clip (single file) recorded from the tape.
4
Press [Extraction Start].
5
Check the message, then press [Yes].
This starts the extraction, analyzes the currently
selected single clip, and automatically extracts a
movie (Clip) or still image (Still). When there is key
data, a pair file is created.
To check the details of the images (still image/
clip)
Set and check the following parameters.
Notes
No. Parameter Adjustment
1 No File number
3 Viewer Timecode for selected image
To Next Page
Loading...
