79
Resizer
Chapter 4 Keys
7
In the <Filter Mode> group, select the method used to
show the picture reduced or expanded.
Mode1 (standard): Even when the picture is reduced,
add compensation so that it can be seen clearly.
Mode2 (soft): Suppress aliasing when expanding or
reducing the picture.
Mode3 (sharp): Do not suppress aliasing when
expanding or reducing the picture.
Resizer Crop/Border Settings
Making a crop setting for a key for which
resizer is on
For example, to make the crop settings for key 1 of the M/
E-1 bank, use the following procedure.
1
In the M/E-1 >Key1 >Processed Key menu (1115),
press [Resizer], turning it on.
2
Press [Border/Crop].
The Border/Crop menu (1115.2) appears.
3
Press [Crop], turning it on.
4
Set the following parameters.
Signs of numeric settings
For H, V, and All settings, the sign (+/–) of the setting
need not be considered. For example, in the case of an
H setting, the value for Left is automatically regarded
as a negative value, and the value for Right as a
positive value, to display the image. The following is
an example of these settings.
5
To soften the edges of the image, press [Edge Soft],
turning it on, and set the following parameter.
(Edges cannot be softened when the Crop effect is
disabled.)
If mosaic is enabled, or if defocus is enabled and in the
<Defocus Mode> group you select Video/Key, then the
crop is disabled.
Applying a border to a key for which
resizer is on
1
In the M/E-1 >key1 >Processed Key menu (1115),
press [Resizer], turning it on.
2
Press [Border/Crop].
The Border/Crop menu appears.
3
Press [Border], turning it on.
4
Set the following parameters.
To apply color to a border
1
In the <Border Mode> group of the Border/Crop
menu, press [Flat Color].
2
Set the following parameters.
No. Parameter Adjustment
1 Mode Degree of motion detection
Parameter group [1/2]
No. Parameter Adjustment
1 H Crop positions on left and right
sides
2 V Crop positions on top and bottom
sides
3 All Crop positions on all sides
Parameter group [2/2]
No. Parameter Adjustment
1 Top Crop position on top side
2 Left Crop position on left side
3 Right Crop position on right side
4 Bottom Crop position on bottom side
Parameter Entered value Setting
H 1.5 Left = –1.50
Right = 1.50
–1.5 Left = –1.50
Right = 1.50
No. Parameter Adjustment
1 Soft Edge softness
Notes
No. Parameter Adjustment
1 H Simultaneously adjust width of
left and right borders
2 V Simultaneously adjust width of
top and bottom borders
3 All Simultaneously adjust width of all
four borders
4 Density Border density
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
To Next Page
Loading...
