Sony MVS-3000 System - Saving a Frame Memory Clip with Ancillary Data; Setting the Number of Format Converter Input;Outputs; System Maintenance; Setting the Date and Time

216
System Maintenance
Chapter 16 System Setup
This carries out the installation, and when it completes
normally, the “Install” box shows “OK.”
Saving a Frame Memory Clip with
Ancillary Data
1 In the Engineering Setup >System >Install/Unit
Config menu (7316), select [SWR1], and press [Unit
Config].
The Unit Config menu (7316.8) appears.
2 Press [FM Ancillary], turning it on.
On: Save with ancillary data.
Off: Save without ancillary data.
Enabling this selection by pressing [Execute] in the
following step reinitializes all frame memory data.
Make backups of required data beforehand.
3 Press [Execute].
4 Check the message, then press [Yes].
Setting the Number of Format
Converter Input/Outputs
1 In the Engineering Setup >System >Install/Unit
Config menu (7316), select [SWR1], and press [Unit
Config].
The Unit Config menu (7316.8) appears.
2 In the [FC Config] group, press one of the following.
8 in: 8 inputs (no outputs)
4 in 2 out: 4 inputs and 2 outputs
3 Press [Execute].
4 Check the message, then press [Yes].
System Maintenance
Setting the Date and Time
1 In the Engineering Setup >System >Maintenance
menu (7317), set the following parameters.
The set date and time appears in the “Set” box in the
status area.
2 Press the [Set Date/Time] button.
Using Removable Disks
Displaying removable disk information
1 Insert the removable disk to the USB connector of the
external monitor or control panel.
2 In the <USB Storage Device> group of the
Engineering Setup >System >Maintenance menu
(7317), press [Refresh].
Formatting a removable disk
Format the removable disk if this is the first time the
removable disk has been used.
1 Insert the removable disk to the USB connector of the
external monitor or control panel.
2 In the Engineering Setup >System >Maintenance
menu (7317), select the removable disk.
3 In the <USB Storage Device> group, press [Format].
4 Check the message, then press [Yes].
Carrying Out the Primary Setting
To specify a removable disk as a primary device, use the
following procedure.
Notes
Parameter group [1/2]
No. Parameter Adjustment Setting values
1 Hour Hour 0 to 23
2 Min Minute 0 to 59
3 Sec Second 0 to 59
Parameter group [2/2]
No. Parameter Adjustment Setting values
1 Month Month 1 to 12
2 Day Day 1 to 31
3 Year Year 2000 to 2037
Notes