238
Screen Saver and Other Settings
Chapter 17 Control Panel Setup
Setting Trackball and Button Double-
Click Sensitivity
You can adjust the sensitivity of the trackball and button
double-clicks.
1
Open the Engineering Setup >Panel >Operation
>Sensitivity menu (7326.5).
2
Make the following settings as required.
Trackball and Z-ring sensitivity in normal mode:
In the <Trackball Normal Mode> group, select
[×1], [×2], or [×4].
Trackball and Z-ring sensitivity in fine mode: In the
<Trackball Fine Mode> group, select [
1
/
2
], [
1
/
4
],
or [
1
/
8
].
Touch sensitivity for recalling menus by double-
clicking buttons: In the <Double Click> group,
select [Fast], [Normal], or [Slow].
Setting the Macro Execution Mode
1
Open the Engineering Setup >Panel >Operation
>Macro menu (7326.6).
2
In the <Macro Execution Mode> group, select the
macro execution mode.
Normal: Normal execution mode
Step: Step execution mode
3
When making a macro attachment setting, select
whether or not to enable cross-point button operations
in the
<Attachment
Sett
ing Mode>
group.
With Btn Function: Enables cross-point button
operations.
W/o Btn Function: Disables cross-point button
operations.
4
Using the <Macro 2nd Recall Mode> group, set the
action to occur during macro execution or when a
macro is stopped, if the cross-point button with the
macro attachment set is pressed again.
Continue: Resumes execution of a macro that has
been stopped (executing macros continue
execution).
Cancel: Terminates execution of a stopped or
executing macro.
5
Using the <Macro Recall Override> group buttons, set
the action to occur during macro execution or when a
macro is stopped, if another macro is recalled.
Disable: Ignores macro recalls.
Enable: Executes other macros.
To have a cross-point button with a macro
attachment set lit continuously
Press [Attchd Btn Indication], turning it on.
When the [MCRO ATTCH ENBL] button in the cross-
point control block is on, the cross-point button with a
macro attachment is constantly lit green.
Screen Saver and Other
Settings
Using the Menu Display Screen
Saver
1
In the Engineering Setup >Panel > Maintenance menu
(7327), press [Screen Saver], turning it on.
2
Adjust the following parameter.
Using Panel Sleep Mode
The brightness of all indicators on the control panel, with
the exception of the menu screen, can be dimmed.
1
In the Engineering Setup >Panel >Maintenance menu
(7327), press [Panel Sleep Mode], turning it on.
2
Set the following parameter.
Adjusting the Brightness
You can adjust the brightness of the following hardware
parts.
LCD Btn Brightness: Adjusts the brightness of the LCD
buttons in the Flexi Pad.
Display Brightness: Adjust the brightness of the organic
EL panel for the source name displays, etc.
Switch Brightness: Adjusts the brightness of the panel
switches.
No. Parameter Adjustment
1 Sleep Time Time until screen saver starts
operation
No. Parameter Adjustment
1 Sleep Time Time of inactivity until panel
sleep mode starts.
To Next Page
Loading...
