86
Basic Procedure for Wipe Settings
Chapter 5 Wipes
2
Press the [WIPE] button, turning it on.
3
Press the [POS] button, turning Position on.
4
Move the trackball to set the wipe position.
By pressing the [X] button, turning it on, you can
restrict movement to the horizontal direction, and by
pressing the [Y] button, turning it on, you can restrict
movement to the vertical direction.
Rotating the wipe pattern (Rotation)
You can rotate the pattern.
Angle
This carries out a wipe with the pattern in a fixed angle.
1
Open the M/E-1 >Wipe >Main Modify menu (1155).
2
In the <Rotation> group, select the rotation type.
3
Depending on the selection in step 2, set the following
parameters.
When Angle is selected
When Speed is selected
When Magnitude is selected
Setting the wipe pattern aspect ratio
(Aspect ratio)
You can freely change the aspect ratio of the pattern.
Table 1: Buttons and assigned settings
Button
name
Setting
WIPE Wipe position for common transition
Table 2: Buttons assigned to functions
Button
name
Function
POS Toggle Position On/Off.
X, Y Fix the operating direction.
CTR Return the pattern position to the center of
the screen.
Speed
Through the course of the
transition the wipe pattern rotates
at a fixed specified speed.
Magnitude
Through the course of the
transition the wipe pattern rotates
through the specified angle.
Angle Off
Angle On
No. Parameter Adjustment
1 Angle Angle of pattern rotation
• A value of –100.00
corresponds to a rotation of
one turn counterclockwise.
• A value of +100.00
corresponds to a rotation of
one turn clockwise.
• A value of 0.00 corresponds to
no rotation.
No. Parameter Adjustment
1 Speed Rotation rate of pattern
• A value of –100.00
corresponds to one
counterclockwise rotation per
second.
• A value of +100.00
corresponds to one clockwise
rotation per second.
• A value of 0.00 corresponds to
pause.
No. Parameter Adjustment
1 Angle Angle of pattern at start of
transition
• A value of –100.00
corresponds to a rotation of
one turn counterclockwise.
• A value of +100.00
corresponds to a rotation of
one turn clockwise.
• A value of 0.00 corresponds to
no rotation.
2 Magnitude Amount of rotation through
course of transition
• A value of –200.00
corresponds to a rotation of
two turns counterclockwise.
• A value of +200.00
corresponds to a rotation of
two turns clockwise.
• A value of 0.00 corresponds to
no rotation.
To Next Page
Loading...
