Sony MVS-3000 System - Deleting an Event

185
Macro Operations in the Flexi Pad
Chapter 14 Macros
2 If required, press the [AUTO INS] button to toggle the
auto insert mode on or off.
3 Create the event.
When auto insert mode (1 p. 184) is on, the event is
automatically added to the macro.
When auto insert mode is off, proceed to step 4.
4 When auto insert mode is off, press the [INS] button.
5 Repeat steps 3 and 4 to insert the required events in the
macro.
Modifying a single event
1 Specify the edit point (1 p. 184).
2 If the [AUTO INS] button is lit, press it to turn off the
insert mode.
3 Create the event.
4 Press the [MOD] button.
Modifying a particular range of events
1 Carry out steps 1 to 3 of the procedure in “Modifying
a single event” (1 p. 185).
2 Press the [FROM TO] button.
This switches the memory recall section to numeric
keypad entry mode.
The alphanumeric display shows the current event
number and the indication “TO.”
3 Carry out the following operations.
• To set the first event in the range to be modified,
press the [CLR] button, then enter the event number
using the numeric keypad buttons, and press the
[ENTR] button to confirm.
• To set the last event in the range to be modified,
enter the event number using the numeric keypad,
and press the [ENTR] button to confirm.
The [FROM TO] button lights green.
4 Press the [MOD] button.
Modifying all events at the same time
1 Carry out steps 1 to 3 of the procedure in “Modifying
a single event” (1 p. 185).
2 Press the [ALL] button, turning it on green.
3 Press the [MOD] button.
Deleting an event
1 Specify the edit point (1 p. 184).
2 To delete a number of events in a single operation,
press the [FROM TO] button or the [ALL] button.
If you press the [FROM TO] button, specify the event
range.
For how to specify a range of events, 1 “Modifying a
particular range of events” (p. 185).
3 Press the [DEL] button.
Moving events
1 Specify the edit point for the start of the range to be
moved (1 p. 184).
2 To move a number of events in a single operation,
press the [FROM TO] button and specify the event
range.
For how to specify a range of events, 1 “Modifying a
particular range of events” (p. 185).
3 Press the [DEL] button.
This deletes the specified events from the macro, and
stores them in the paste buffer.
4 Move to the edit point which is the destination within
the macro to which you want to move the events.
5 To insert the move target events after the edit point,
press the [PSTE] button.
To insert the move target events before the edit point,
hold down the [SHFT] button and press the [PSTE]
button.
Copying events
1 Specify the edit point for the start of the range to be
copied.
2 To copy a number of events in a single operation, press
the [FROM TO] button or the [ALL] button.
If you press the [FROM TO] button, specify the event
range.
For how to specify a range of events, 1 “Modifying a
particular range of events” (p. 185).