Sony MVS-3000 System - Data Saved by [Initial Status Define]; Error Messages

298
Error Messages
Appendix
Included in Switcher Setup
Data Saved by [Initial Status Define]
Included in Panel
Included in Switcher (Same as data saved in Snapshots)
Error Messages
Error messages appear in the following three formats.
• A list display in the Error Status menu (7411)/Error Log
menu (7412)
• Message boxes
• List based on the Error Information menu (9900)
Menu No. Menu path Saved data
3221 Misc >Safe Title All data relating to Safe Title menu
7322.5 Engineering Setup >Panel >Xpt Assign >Main,V/K Pair
Assign
Cross-point assignment settings (excluding <Xpt Shift
Mode> and <Display Shift Mode> groups)
7322.6 Engineering Setup >Panel >Xpt Assign >Src Name/
Src Color
Names of source signals
7326.2 Engineering Setup >Panel >Operation >Effect Mode Setting of [Default KF Duration] for switcher keyframes
7331 Engineering Setup >Switcher >Config All data relating to Config menu
7332 Engineering Setup >Switcher >Input All data relating to Input menu
7333 Engineering Setup >Switcher >Output All data relating to Output menu
7334 Engineering Setup >Switcher >Transition All data relating to Transition menu
7335 Engineering Setup >Switcher >Key/Wipe/FM/CCR All data relating to Key/Wipe/FM/CCR menu
7336 Engineering Setup >Switcher >Link All data relating to Link menu
7337 Engineering Setup >Switcher >Device Interface All data relating to Device Interface menu
Menu No. Menu path Saved data
- - • Settings for the following cross-point control block buttons
- Delegation buttons assigned to the 1st row
- [1ST ROW DSPLY], [2ND ROW DSPLY], [SHIFT], [MCRO ATTCH
ENBL]
• Transition control block: [KF], [SHIFT], and independent key transition
[KEY1] to [KEY4] buttons
• Flexi Pad: Settings for the [WIPE], [DME WIPE], [SNAPSHOT], [EFF],
[SHOTBOX], [MCRO], [TRNS RATE], [KEY ADJ], [KEY SS] buttons
6351 Snapshot >Key Snapshot >Attribute Settings of <Recall Mode> group
Menu No. Menu path Saved data
- - • For each M/E, setting data relating to the following:
cross-points, transitions, Key1 to Key4 (including independent key
transition settings), wipes, DME wipes
• Color backgrounds 1/2
• Frame memory
• AUX bus (including CCR settings)
3211 Misc >Enable >Port Enable Setting data for <Switcher> group
3213 Misc >Enable >Side Flags All data relating to Side Flags menu