127
Router Control Menu Operations
Chapter 8 Color Backgrounds, Copy and Swap, and Other Settings
To set an RGB clip: Turn on [RGB Clip] in the <RGB
Clip> group, and select the item to set in the <RGB
Clip Adjust> group.
4
Set the parameters.
For details about the parameters, 1 “Configuring
the Color Corrector” (p. 242).
To disable color correction
In the <CCR> group, press [CCR], turning it off.
To return the parameters to their default settings
Press [Unity].
Router Control Menu
Operations
You can control router switching in the Router Control
menu.
Checking the List of Inputs for Each
Destination
Open the Router >Router Control >Router Control menu
(5111).
A list of destination assignments appears on the left side of
the status area.
If in the Engineering Setup >Panel >Router Remote >RTR
Mode Setting menu (7323.1), [Inhibit] is set to On for a
destination, the corresponding line appears in gray. Also,
if [PROT] (protect) is set to ON for a source, using a BKS-
R3xxx or R1xxx series Router remote control, a padlock
icon appears.
The right side of the status area shows the level assignment
status to the Level 1 to Level 4 buttons.
Selecting the level
In the <Level Button No> group at the lower right in the
above illustration, press the level for switching.
Switching the Source for Each
Destination
You can switch the source for each destination with a
menu operation.
For the assignment of destinations and sources to buttons,
use the Engineering Setup >Panel >Router Remote >RTR
Mode Setting menu (7323.1).
For details, 1 “Router Remote Control Settings”
(p. 226).
1
In the Router >Router Control >Router Control menu
(5111), press [Change Xpt].
The Change Xpt menu (5111.1) appears.
Destination Select buttons appear in groups of 16.
Source Select buttons appear by group (maximum 24
buttons).
2
Press one of the Destination Select buttons, to select
the destination for which you want to switch the
source.
To change the group
Press one of the [1-16], [17-32], [33-48], and [49-64]
buttons.
3
Press one of the Source Select buttons, to select the
source you want to switch.
To change the group
Press one of the [1-24], [25-48], ... [97-120], and [121-
128] buttons.
To Next Page
Loading...
