29
Names and Functions of Parts of the Control Panel
Chapter 2 Names and Functions of Parts
b EDIT ENBL (edit enable) button
This enables the following operations.
• Effect creation/editing
• Snapshot attribute setting
• Shotbox creation/editing
• Macro creation/editing
•Wipe adjustments
•DME wipe adjustments
c Region selection buttons
These select the functional block (“region”) of the control
panel to which operations apply.
When the [EFF], [SNAPSHOT], [SHOTBOX], or
[MCRO] mode selection button is selected, you can select
multiple region selection buttons simultaneously. In this
case, the first button pressed lights green as the reference
region, and the other buttons pressed light amber (the
buttons for the regions shown in the memory recall section
are yellow).
d Alphanumeric display
This shows the selected region name, register number, and
entered numeric values.
e Memory recall section
This comprises 16 LCD buttons, each with a display that
changes according to the operating mode.
f Adjustment knob displays
Each of these shows the initial letter of the parameter that
can be adjusted with the knob to the right, and the setting
value (three digit places, including the minus sign).
g Adjustment knobs
Use these to adjust the parameters selected with the
memory recall section buttons.
KEY SS (key
snapshot)
Press this to carry out key snapshot
creation/recall/deletion.
By default, this is not assigned to a mode
selection button, so you must assign it to
a mode selection button in the Setup
menu before use.
Name Description
ALL • Selects all regions.
• If any region is selected, press this
button to unset the selection of all
regions.
M/E1, P/P Select the M/E-1 and PGM/PST regions,
respectively.
USER4 Selects the USER4 region.
DEV1 Selects the device 1 region.
Name Description
MORE • Displays buttons in the memory recall
section for regions not assigned to a
region selection button, so that they
can be selected.
• By default the following regions are
shown on the memory recall section
buttons:
MSTR (master snapshot, master
timeline registers), USER1 to 3,
USER5 to 8, MCRO (macro), DEV2
(device 2), PBUS, GPI, RTR (router)
• If there is a region selected in the
memory recall section, this is indicated
by the MORE button lighting green.
• To revert the button displays in the
memory recall section, press the
[MORE] button once more, or press the
[EXIT] button that appears in the
memory recall section.
• Note that except for the [ALL], [EXIT],
and [MORE] buttons, you can freely
change the region assignments in the
Setup menu.
Name Description
To Next Page
Loading...
