152
GB
To change the display
You can check the sound field, etc., by
changing the information on the display.
1 Select the input for which you want to
check the information.
2 Press DISPLAY repeatedly.
Each time you press DISPLAY, the display
will change as follows.
Input you selected t Sound field type t
Input name you entered ...
When listening to FM and AM radio
Station name t Frequency t Sound field
type...
Index name appears only when you have
assigned one to the input or preset station.
Index name does not appear when only
blank spaces have been entered.
When tuning in a channel from a satellite
tuner (USA/Canadian model only)
Channel name t Channel number t
Category t Artist name t Song title t
Composer name (SIRIUS only) t Signal
strength t Sound field type
When receiving RDS broadcasts (European
model only)
PS (Program Service name)
a)
, Preset name,
Band, or Preset number t Frequency,
band and preset number t PTY (Program
Type) indication
b)
t RT (Radio Text)
indication
c)
t Sound field type
a)This information also appears for non-RDS
FM stations.
b)Type of program being broadcast
c)Text messages sent by the RDS station.
HDMI Settings CTRL FOR HDMI [xxx]OFF, ON OFF
PASS THROUGH [xxxx] OFF, AUTO, ON OFF
AUDIO OUT [xxxxxx] TV+AMP, AMP AMP
24p SOUND SYNC [xxx] OFF, ON ON
SW LEVEL [xxxdB] AUTO, +10dB, 0dB AUTO
VIDEO DIRECT [xxx]OFF, ON OFF
System Settings NAME IN ? [xxxxxxxx]
PARTY SETUP [xxxxxxx] ZONE2/3, ZONE2, ZONE3 ZONE2/3
12V TRIG. MAIN [xxxxx] OFF, CTRL, ZONE, INPUT, HDMI A,
HDMI B
OFF
12V TRIG. ZONE2 [xxxxx] OFF, CTRL, ZONE, MAIN OFF
12V TRIG. ZONE3 [xxxxx] OFF, CTRL, ZONE, MAIN OFF
INSTALLER MODE [xxxx] OFF, 232C, NET OFF
VERSION [x.xxx]– –
Menu Item Parameter Initial
setting
To Next Page
Loading...
