If no sound is heard from a speaker while
outputting a test tone or a test tone is output
from a speaker other than the one whose name
is currently displayed on the receiver, the
spe‘aker may be short-circuited. If this happens,
check the speaker connection again.
Make sure that you turn down the volume
before you turn off the receiver. When you turn
on the receiver, the volume remains at the level
you
turn off the receiver.
Once you have hooked up the speakers and
turned on the power, cle<ar the receiver’s
memory. Then specify the speaker parameters
(size, position, etc.) and perform any other
initial setup operations necessary for your
system.
2-I
‘To check the audio
output
during settings (to set up
while outputting the sound), cheek the connection
(page
251.
Before using your receiver for the first time, or
when you want to cle<ar the receiver’s memory,
~‘~EMORK CLEARING”, then
“PRIORY CLEARED” appears in the
display and all of the following items are
reset or cleared:
*
All preset stations are reset or cleared.
*
All sound field parameters
are
reset to
their factory settings.
e
All index names (of preset stations and
program sources) are cleared.
* All SET UP and CUSTOMIZE
parameters are reset to their factory
settings.
0
The sound field memorized for each
program source and preset stations <are
cleared.
e The master volume is set to VOLUME
MIN.
Before using your receiver for the first time,
adjust SET UP parameters so that the receiver
correspond to your system. For the adjustable
parameters, see the table on page 66. See pages
20-25 for speaker settings.
For the best possible surround sound, all
speakers should be the same distance from the
Rowever, the receiver lets you to place the
ter speaker up to 1.5 meters (5 feet) closer
), the surrou
eakers up to 4.5 meters
feet) closer
nd the surround bat
speakers up to 4.5 meters (15 feet) closer
to the listening position.
The front speakers can be placed from 1 .O to
(3 to 40 feet) from the listening
You
can place the surround speakers either
behind
yw
or to the side, depending on the
shape of your room (etc.).
To Next Page
Loading...
