med button to activate the function
3E during my step. The remote
tits the learning mode.
I
a
step 2. After step 3, press
re than 2 seconds. The iradicator
viy and the learned code is
/& is pressed less than 2
rning pmcedure returns to the
:p 5.
code is cleared, if the button
programmed for another
lgrammed code for that button
; to reset the remote to factory
r%ss I/O,
ri/o, and
ashes 3 times, then goes off.
a learned fmmiion, press the
‘or that ftmction.
The Macro Play function lets you link several
LBp codes in a sequential order as a single
mmnmd. The remote provides 2 macro lists
(ML and MZ). You cm specify up to 10 IF.
codes br each macro list.
The indicator lights.
For example, to program step I, press 1.
The indicator blinks slowly.
ssing the button once should be
m&ient.
K learning is completed successfully, the
iadicatm slowly flashes twice and the
remote automaticalily exits the learning
mode.
When leaming is not completed
successfully, the indicatm flashes 4 times in
quick sarccessiorm and the procedure retm-ns
to step 4.
If
programming is unsuccessful, check the
follwing:
- If the indicator does not light up in step 1, the
batteries are weak. Replace both batteries.
- If the indicator lights 4 times in quick
succession in step 3, an error has
occured. Start
again from step I.
oen
.
Press USE MODE during any step. The remote
automatically exits the macro setting mode.
om step 1. In step 3,
(TV/SAT) when the macro setting
e Press M2 (TAPE) when the macro setting is
M2.
1 second delay is programmed at this program
step. The indicator lights twice slowly, then the
remote automatically exits the macro setting
mode.
e Press Ml (TV/SAT> whet3 the macro setting
is Ml.
e Press M2 (TAPE) when the macro setting is
M2.
The B code is cleared. The indicator Bights
twice slowbj~, then the remote automatically
exits the macro setting m5de.
If the Macro Pky function does not work properly,
program a delay between each operation. See “To
delay
the output
of an IX code”.
To Next Page
Loading...
