P
you do not remember the precise frequency, press
TUNING + or TUNING - after entering the value
close to the frequency yon want. The receiver
automatically tunes in the station you want. If the
frequency seems to be higher than the entered
value, press TUNtNG f, ‘and if the frequency seems
to be lower than the entered value, press
TUNING -t
0 If “STEREO” flashes in the display and the FM
stereo reception is poor, press FM MODE to change
lo monanral (MONO). You will not be able to enjoy
the stereo effect, but the sound will be less
distorted. To return to stereo mode, press FM
MODE again.
The tuning scale differs depending on the area code
as shown in the following table. For details on area
codes, see page 4.
U, CA
-.
100 kfiz
10 kKz”
* The AM tuning scale can be changed (page 62).
If you don’t know the frequency of the station
you want, you can let the receiver scau all
available stations in your area.
tc? FU
The last received station is tuned in.
press
TUNLNC
- to scan from high to low.
The receiver stops scamriug whenever a
station
is received.
After you have tuned in stations using Direct
Tuning or Automatic Tuning, you can preset
them to the receiver.
Then you can tune in any
of the stations directly by enteriug its
2-character preset code usiug the supplied
remote. Up to 30 FM or AM stations can bc
preset. The receiver will also scan all the
stations that you have preset.
Before tuning to preset stations, be sure to
preset them by performing steps on “Presetting
radio stations”.
The last received station is tuned in.
“~~~OR~ appears in the display for a
few seconds.
Do steps 4 to 6 before “MAYORS goes
out.
to ~~~~~
e
ou press SHIFT, the letter “t\“,
“‘B”, or “‘G” appears in the display.
the preset number, start again from step 3.
to St
ORu” goes out before you can
store the station, start again from step 3.
Do steps 1 to 6 to preset a new station to the
number.
You can tune the preset stations by either of the
following two ways.
I-
utton, the receiver
tunes in one preset station at a time, in the
corresponding order and directiou as
follows:
Al++A2t-r...spAO++Bl~+B2t+...+-+BO
LCO-...C,*Cl
rform the
following operations. For details on the buttons
used in this section, see pages 48-57 for remote
~-P~411 and pages 4%S5 for remote
The last received station is tuned in.
To Next Page
Loading...
