Sony STR-DE985 - Selecting the mode of the remote; Selecting the command mode; To reset the remote to factory settings

Set tie retnote mode using the USE MODE
button and the remote mode buttons.
YoLn can switch the c5rmna~d mode (AW or
AWj of the remote. If the commancI mode of
the receiver and the remove is &Eerent, yore
cmnot me the remote to operate the receiver.
The indicator lights once (twice for AV2) _ then
the command mode switches.
You can use the remote CO select the function
for the 2nd room (2nd mom modee). You can
use the function buttoas o&y for the 2nd mom.
Me, then the mode
switches to the 2nd room mode.
e If you press a function button while pressing down
SOURCE, you can sdect the function for the 2nd
room even though the mode is not set to the 2nd
room mode.
0 If you press SOURCE only, you can output the
source signal of the current function of the receiver
to the amplifier in the 2nd room.
Press USE MODE. You cm check the remote
by the idicator.
AVI
AT?
once
twice
t
The indicator lights 3 times, then goes OR.
You can program the remote to c~ntml non-
Sonay components by changing the code. Q)nce
the control signals have been memorized, you
can use those compon.ents as part of your
system.
Furthermore, you can also program the remote
for Sony components that. the remote is tmable
to conthol. Note t&Z the remote can only
coplt.rol components that accept infrared
wireless coritrol signals.
The indicator lights.
Pm example, if you are going to control a
CD player, press CD/SKIP.
See the tables on pages 54 and 55 for
information on the numeric code(s)
corresponding to the component ;md the
maker of the componetxt (the f&t digit and
the last two digits of the numeric code
correspond to the category and the maker’s
cede respectively.)
c code has been verified,
the indicator slowly Bashes twice and the
remote a&xnaticaEy exits the programming
mode.
remote automatically exits the programming
mode.
Press the programmed button to activate The
fimction you want.
Q Z the indicator does not light up in step I, the
batteries are weak. Replace both batteries.
* If the indicator flashes 4 times in quick succession
while entering the numeric code, an error has
occurred. Start again from step 1.
* The
indicat,
pressed.
- In step 2. if
only the 1%
= In step 2, if
TV c3-I 4-b
reprogramr
* h step 3, if
function is
returns to tl
0 For the mm
entered ax
da the folio
settings.
The i&cat
Use the nm
colltrQl non
component
to ComoL
component
model and
one rmmeti
component
using me E
* The
numer
inform&o
chance, ho
respond to
e Allof the
available 1
componen