Command Descriptions
3-60
VX4792 User Manual
*OPC (?)
The common command generates the operation complete message by
setting bit 0 in the SESR (Standard Event Status Register), when all pending
operations are finished.
The query returns a “1” ASCII character when all pending operations are
finished.
SYNCHRONIZATION
None
(serial poll used) or (service request used)
or (start operations)
The above sequence sets up the system to wait until all pending operations are
finished, which occurs when the ASCII character 1 is returned to the controller.
Note that different commands are used depending on whether serial poll or
service request handler is used for synchronization.
Group
Related Commands
Syntax
Arguments
Examples
To Next Page
Loading...
