193
g End of video content
To play audio
Set the [Audio On] switch to the on state.
To repeat playback (looping)
1
Press the [Set Loop Playback] button.
The [Set Loop Playback] window appears.
2
In the [Loop Mode] group, set repeat playback.
Off: Turns re
peat playback off.
Loop: Lo
op playback. When the playback stop point
is reached, playback continues from the playback
start point.
When the [Loop] button is selected, set the number of
repet
itions in the [Repeat] group.
Set the repetitions radio button
to the on state, press
the input field, and enter the number of repetitions in
the numeric keypad window.
To repeat indefinitely, set the [Infinite Loop] radio
bu
tton to the on state.
3
Press [OK].
To change the playback speed
Set the [Variable Speed] button to the on state and set the
foll
owing parameter.
When the [Variable Speed] button
is set to the on state,
audio is not played.
Playing video (device control block)
The device control block can be switched to device/frame
memory/clip player operation mode for playback control
of video.
For details about the operation buttons in device/frame
memory/
clip player operation mode, see “VTR/disk
recorder operations” (page 218).
The buttons used for selecting a clip player output
channe
l must be assigned to the device control block
beforehand.
For details about assign
ing buttons, see “Assigning
Control Panel Buttons” (page 397).
1
Press the [DEV] button.
The [DEV] button is lit amber, and
the operation
mode switches to device/frame memory/clip player
operation mode.
2
Press the [CLIP1] button.
The [CLIP1] button is lit green, and c
lip player output
channel 1 becomes the target of operations.
When group mode is enabled, the buttons for the two
combined
clip player output channels are lit.
3
Press the [PLAY] button.
The [PLAY] button is lit ambe
r, and playback starts.
To stop playback, press the [STOP], [CUE], [REW],
[
FF], or [ALL STOP] button.
Video playback operations
Operate using the following buttons.
Pause playback
Playback
Move to video playback stop point
Move to end of video content
Set current position as playback start
po
int
Set current position as playback stop
po
int
No. Parameter Adjustment
2 Clip 1 Speed Playback speed (0% to 100%)
Note
Button Operation
Note
Button Operation
FM LOOP Repeat (loop) playback
START TC Set current position as playback start
po
int
STOP TC Set current position as playback stop
point
STOP Pause playback
CUE Move to video playback start point
REW Move to start of video content
PLAY Playback
FF Move to end of video content
ALL STOP All stopped
To Next Page
Loading...
Need help?
General
