427
Configuring Remote
Cameras
You can register remote cameras to be controlled using
the switcher. Up to 32 cameras can be registered.
1
Open the Home > Setup > External Device > Remote
Camera > Remote Camera Settings menu (19105.71).
A list of the registered remote cameras appears.
2
Press the [Add] button.
The [Add Remote Camera] window appears.
3
Press the [IP Address] button and enter a camera IP
address using the keyboard.
Entering an IP address a
utomatically sets the
following information.
ID: ID number (1 to 32)
Camera Name: Camera name
Status: Camera connection status (“Connected” or
“Not
Connected”)
If the camera with the entered IP address is not
c
onnected
A message appears when you enter the IP address.
Press [OK] to continue
the registration.
4
Press [OK].
A message appears for an unconnected camera. Press
[OK
] to apply the remote camera registration.
To cancel a remote camera registration
Select the target remote camera to cancel, press the
[De
lete] button, check the message, then press [OK].
To Next Page
Loading...
