Sony XVS-G1 - Shotbox Register Operations

302
Executing a Shotbox (Menu)
1 Open the Home > Register > Shotbox > Edit Shotbox
menu (18306.11).
2 In the list on the left, select the target shotbox register
to recall.
You can also press the [Select Register] button and
e
nter a register number in the numeric keypad
window.
3 Press the [Recall] button.
The shotbox is recalled.
When auto run is enabled, the registered effect
t
imeline is executed at the same time the register is
recalled.
To execute an effect timeline
In the [Effect Timeline Recall/Store] taskbar, press the
[Run
] button.
To move to the start point of a
n effect timeline, press the
[Rewind] button.
• When auto run is disabled, an effect timeline is not
exec
uted when a shotbox register is recalled. Press the
[Run] button to execute.
• You can set the operation when the [Run] button is
p
ressed again during effect timeline execution.
For details, see “Setting the operation w
hen the [RUN]
button is pressed during effect timeline execution”
(page 416).
Shotbox Register
Operations
Displaying a Shotbox Register
Open the Home > Register > Shotbox > Edit Register >
Browse menu (18306.21).
You can check the following information.
• Register number
•Register name
• Lock icon
A lock icon is displayed when a register is locked.
• “Run” icon
A “Run” icon is displayed when auto run is set for a
register.
• Region display
Displays the regions registered i
n the register in white
characters.
When the [Edit Shotbox] button is pressed, the Home >
Re
gister > Shotbox > Edit Shotbox menu (18306.11) is
recalled.
For details, see “Creating and Editing a Shotbox”
(page 298).
Setting auto run
You can set auto run for a register.
Auto run cannot be set for a locked register.
1 Open the Home > Register > Shotbox > Edit Register
> Browse menu (18306.21).
2 Select the target register to set.
To select and set multiple registers, place a check
m
ark beside the target registers to set.
To select and set all registers, place a check mark in
the
Select All checkbox.
You can also press the [Select Register(s)] button and
ent
er a register number in the numeric keypad
window.
3 Set auto run.
To enable auto run
Press the [Auto Run On] button.
To disable auto run
Press the [Auto Run Off] button.
Notes
Note