Sony XVS-G1

301
Executing a Shotbox (Utility Control
Block)
You can recall a shotbox using the utility control block in
utility/shotbox operation mode.
1 Press the [UTIL/SBOX] button.
The memory recall section switches to utility/shotbox
op
eration mode.
2 Select a bank.
For details about selec
ting a bank, see “Selecting a
bank” (page 236).
3 Press the button for the target register to recall.
When a button assigned with a shotbox register is
pressed,
the button is lit orange and the shotbox is
recalled.
When auto run is enabled, the registered effect
t
imeline is executed at the same time the register is
recalled.
To execute an effect timeline
Press the [RUN] button.
When stopped by a pause, the [RUN] button is lit green.
Pre
ss the [RUN] button, lighting it amber, to resume
effect timeline execution.
To move to the start point of a
n effect timeline, press the
[REWIND] button.
• When auto run is disabled, an effect timeline is not
exec
uted when a shotbox register is recalled. Press the
[RUN] button to execute.
• You can set the operation when the [RUN] button is
p
ressed again during effect timeline execution.
For details, see “Setting the operation w
hen the [RUN]
button is pressed during effect timeline execution”
(page 416).
Executing a Shotbox (Cross-Point
Control Block)
You can recall a shotbox using a cross-point button row
assigned with a utility/shotbox bank.
1 Select a bank.
The target utility/shotbox bank is assigned to a cross-
po
int button row.
For details about selec
ting a bank, see “Selecting a
bank” (page 236).
2 Press the button for the target register to recall.
When a button assigned with a shotbox register is
pressed
, the button is lit amber and the shotbox is
recalled.
When auto run is enabled, the regist
ered effect
timeline is executed at the same time the register is
recalled.
To execute an effect timeline
Use the utility/shotbox
control block, utility control
block, or the menu.
For details about executing usi
ng the utility/shotbox
control block, see “To execute an effect timeline”
(page 300).
For details about executing using the uti
lity control block,
see “To execute an effect timeline” (page 301).
For details about executing using the menu, see “To
execute an effect timeline” (page 302).
Executing a Shotbox (Numeric
Keypad Control Block)
You can recall a shotbox using the numeric keypad
control block in shotbox operation mode.
1 Press the [SHOTBOX] button.
The [SHOTBOX] button and [RCALL] button turn
on amber, and
the numeric keypad control block
switches to shotbox operation mode.
2 Select the target register to recall.
Enter a register number in the numeric keypad area.
For details about selecting a register, see “Selecting
a register” (page 258).
3 Press the [ENTER] button.
The shotbox is recalled.
When auto run is enabled, the regist
ered effect
timeline is executed at the same time the register is
recalled.
To execute an effect timeline
Use the utility/shotbox control block or the menu.
For details about executing usi
ng the utility/shotbox
control block, see “To execute an effect timeline”
(page 300).
For details about executing using the menu, see “To
execute an effect timeline” (page 302).
Notes